close
North America
Brooks Instrument Thermal Mass Flow products (TMF) are available for services of calibration, reconditioning, and reconfiguration at these locations with two levels of service;
- Level 1 Service involves purge and calibration only at a reduced cost.
- Level 2 Full Service and repair includes inspection, repair, reconditioning, calibration and reconfiguration services. Complete diagnostic review available upon request.
All of our North American support centers offer the following services:
- Preventive Maintenance Programs
- As Found/As Left Calibration Reports
- Failure Analysis Reports
- Technical Support, On-site start up, field calibrations, and training services
Hatfield, PA
- Calibration, recondition and reconfiguration of Brooks Instrument thermal mass flow, variable area and Quantim Coriolis mass flow products. Thermal mass flow products serviced: Analog, Smart Analog, Delta, Smart II product series
- NIST Certification
- High Flow Calibrations up to 2400 SLPM N2 equivalent
- Up to 1500 PSIG inlet pressure
- Direct gas calibration: N2, H2, Argon, Helium, CO2, Air
Phone: 888-554-3569
Austin, TX
- Calibration, recondition and reconfiguration of Brooks Instrument Thermal Mass Flow Controllers products. Thermal mass flow products serviced: Analog, Smart Analog, Delta, Smart II product series
- Class 100 clean room
- NIST certification
- Flow rates up to 30 SLPM N2 equivalent
- Up to 350 PSIG inlet pressure
- Direct gas calibration: N2, Argon, Helium
Phone: 512-873-8000
